Category Archives: Microcontroller

Pin locations of the 4 new Pins on the Arduino Uno Rev3

Picture of Arduino Uno R3 Drawing showing location of 4 new pins

Arduino Uno R3 Drawing showing location of 4 new pins

This picture shows the dimensions of the pin locations of the 4 new pins on the Arduino Uno R3. The Arduino Uno R3 is the board being sold by RadioShack

Follow this link to see more pictures about the four extra pins on the Arduino Uno Rev3 ZappBots Forum Post

Advertisements

Arduino Uno Rev 3 and (Arduino) Ethernet Shield Rev 3, have four new pins

The Arduino Uno Rev 3 and (Arduino) Ethernet Shield Rev 3, have four new pins.

Arduino Uno R3 Front with 4 new pins circled

Arduino Uno R3 Front with 4 new pins circled

Here are the main differences between the R3 and previous versions:

  • The USB controller chip has been upgraded from an ATmega8u (8k of flash memory) to an ATmega16u (16k of flash memory.) This new chip should make it easier to emulate input devices like joysticks, mice, MIDI interfaces, and keyboards (this has not yet been tested and there is no code yet.)
  • Analog pins 4 and 5 have been broken out next to the AREF pin to allow for I2C communication. This makes it easier for future shields to be compatible with both UNO’s and MEGA’s. Also, the power pin has been duplicated next to the RESET pin to let shields know what voltage they are running (in the case of the UNO it’s 5 volts.)
  • The reset button has moved next to the USB input for easier accessibility while a shield is in place.

 

Follow this link to see more pictures about the four extra pins on the Arduino Uno Rev3 ZappBots Forum Post

 

Zapp-Bot Tank-Tread Robot featured at www.limoncellodigital.com

On October 1, 2011 my Zapp-Bot Tank-Tread Robot is featured at http://www.limoncellodigital.com/

Welcome to ZappBots

Welcome to ZappBots

This site was started on 9/29/2011.

Choose the  “Robot” tab to see more information on the ZappBot Robots.

Our Featured Video